Slip Knot

Slip Knot

Recruit
Thread starter
Joined
Oct 26, 2011
Messages
1
Rookie in the cuddy cabin world....
Can't get the cabin lights to work...none of them. Checked fuses, replaced bulbs, no luck.
I just got a 90 Rinker Fiesta Vee 250...and feeling a little silly not being able to make the lights work...Help anyone ?
 

QC

Supreme Mariner
Joined
Mar 22, 2005
Messages
22,783
Re: Slip Knot

I'm going to move this to the electrical section. This will not be a Rinker specific answer I suspect.

Do you have 12V to the fuses and the light fixtures? Is there any switches on the dash for Courtesy lights? Any type of panel with switches in the cabin? Battery(s) switch is on right? Have to ask . . . :)

Oh, oh . . . welcome aboard!!
 

Philster

Captain
Joined
Sep 15, 2009
Messages
3,344
Re: Slip Knot

For starters: You need to trace the wires as much as possible to ensure connections and grounds are okay.... and need a electrical tester to narrow it down. I mean, why get a twisted neck checking/tracing wires through the cabin if the fuse panel isn't even showing any juice?

Didn't see you say that you checked the actual switch(es). Also, I'd be spraying every contact with something to rid them of corrosion.
 

oops!

Supreme Mariner
Joined
Oct 18, 2007
Messages
12,932
Re: Slip Knot

this sounds like a single switch or possibly a ground in a panel.....ya gotta keep looking.

even a 25 footer will have a main connection area......

possibly under the dash......or a main board in the cabin
 

Fireman431

Rear Admiral
Joined
Sep 17, 2007
Messages
4,292
Re: Slip Knot

Also check to see if you have a master breaker or power switch for cabing accessories. Some are equipped this way so a flip of a switch cuts everything off in the cabin.
 

willocreek1202

Seaman Apprentice
Joined
Oct 6, 2011
Messages
37
Re: Slip Knot

Use a Volt Meter and check for 12 volts at the switch. If you don't have voltage there check main panal fuzes and power to it. Main thing is to have an Volt Meter. Most meters will measure ac, dc and ohms. Use the dc to check for proper voltage and the ohms for continuity.
 
Last edited:

fucawi

Banned
Joined
May 18, 2011
Messages
1,039
Re: Slip Knot

you dont check for Volts with an ohm meter....??? I think you mean multimeter....

When I make a **** up in a post i always go back and change it so it does not mislead anyone.
 

Newowner2011

Petty Officer 3rd Class
Joined
Sep 19, 2011
Messages
94
Re: Slip Knot

Where you from Slip Knot ? I used to know a guy that had the nickname Slip Knot who lived in Gorham,Maine
 
Top