Should I be concerned ?

jhud

Cadet
Thread starter
Joined
Aug 17, 2014
Messages
14
First off, thanks for the helpful replies with my project. I just finished a first time rebuild on my 95 Evinrude 90. I fired her up this morning and seems to be running fine except the idle is around 1000 RPMs on the ear muffs. I am running 25:1 in the tank and have not had the throttle and timing synchronized yet. My concern is after running for about 10 min I pulled the plugs and the starboard side top and bottom look like I would expect. A little wet with a small bit of oil on the outside of the electrode but the port side looks pretty dry and clean especially the top one should I be concerned ?
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Do a cylinder drop test on it to see if it's running on all four cylinders.
 

jhud

Cadet
Thread starter
Joined
Aug 17, 2014
Messages
14
Update: I pulled the carbs off and cleaned them again. Put back together and instantly noticed a lot more smoke than before. The first time I ran it it didn't seem to smoke much more then it ever did even though I am running 25:1. Now its smoking like a champ and there is a little wetness and oil on the plugs hope its good now.I guess I'll take her to the lake and see if she blows . LOL.......
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Agree with boobie. You really don't want to run the engine if one cyl is not getting fuel. If it's not getting fuel, it's not getting any lube oil and that would be a problem. When you are idling the engine on the trailer, pull each spark plug wire of each plug-one at a time. You should see the engine rpm's drop each time you pull one plug wire off. If you see no rpm drop, the cyl is either not getting spark or fuel. It's the "no fuel" scenario that would be the problem.
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,437
Prior to running for any length of time, you will need to do a link n sync
 
Top