Shifting problems 1977 johnson

Rhurd

Recruit
Thread starter
Joined
Aug 4, 2016
Messages
5
I have a 1977 Johnson which runs like a dream. Problem is you can adjust it where it goes into forward but then you have no reverse. Same with reverse, but then you have no forward. I had a boat mechanic take lower unit apart and check he said everthing looked great. We checked the shift rod height. I put all new bushings on every pivot point from control box thru the motor to take out all slack. Thouroughly inspected the shift cable. I am at a complete loss for the next step in trouble shooting this. You can take the cowling off and assist it into the opposing gear. And it is smooth. Please,, desperate for an answer. As I have completely restored the boat and this is the only thing left for it to be perfect. Help
 
Last edited:

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
So does this problem exist with the remote shift lever at the boat driver seat? If so, you probably need a new shift cable. Over the years, someone probably cut off the inner cable and made it too short to give enough throw in both forward and reverse.
 

Rhurd

Recruit
Thread starter
Joined
Aug 4, 2016
Messages
5
The cable apears to have factory ends on both ends. I believe the control box is a 1982 omc this motor is not the original that came with boat. The boat is an 1982 pontoon
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
The cable ends changed starting with models 1979 and later. You are trying to mix an older engine with a later model control box. That could be part of the problem.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
How many curves and bends do you have in the cable? Bends and curves create slack that add up. Internal wear in the cable adds to the slack too. Grab the motor end of the cable and see if you can pull/push it in and out. Does it seem excessive? With respect, I don't think it is a matter of the year/design. The old pre-'79 cables were worse because they were subject to human tampering. Not much you can do to mess up a post-'79.
 

Rhurd

Recruit
Thread starter
Joined
Aug 4, 2016
Messages
5
F_R no slack in cable, only slack I can find at all is in the plastic gears in the controller but there apears to be no wear. But with the box apart and with it engaged in forward or reverse you can push it another 1/4inch in F or R and that could make the difference but no signs of wear at all and well greased when i took it apart the first time. Did not appear that they needed to be replaced.
 
Top