shifting issue after replacing throttle cable on 1974 evinrude 400 series cable

potterswheelnc

Recruit
Thread starter
Joined
Jun 19, 2016
Messages
1
I'm going down a rabbit hole with this boat and I need to stop. After putting the boat in the water the first time I found out that the throttle cable was shot so I replaced it and now I'm getting full throttle but it won't start. Nothing happens when I turn the key. The battery is charged and I'm getting power to the ignition switch which is new. I feel that the transmission is in forward and the neutral saftey switch is not on due to the key doing nothing. The shifter won't go into reverse. The prop turns freely no matter what the shifter is doing. How can I start to fix this? Thanks for any help.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Begin by disconnecting both cables from the motor and try the throttle & shifter (on motor). If those are working properly, then install and adjust the control cables to motor. Always adjust the controls to fit the motor, never adjust the motor to fit the controls.

While you are doing all this, remember you may not be able to shift the motor if it is not running--or at least spin the prop to simulate running. And an interlock prevents high throttle settings in neutral or reverse, and likewise if in gear and fast throttle setting you cannot shift to neutral without backing off on throttle to a slow position.
 
Top