Hi everyone. I am new on this forum and need your help. First let me say that I have read alot of post regarding my motor model & year. 1973 evinrude starflite 85hp 85393m model. Fantastic motor. I am searching for how to remove the shift rod from the lower unit (not from the motor up top,! From the lower unit) I have disconnected the rod from up top and have removed the lower unit with success. I am attempting to reseal all lower unit seal including changing the water pump n propeller. ( I'm assuming this subject has been covered extensively, but am unable to find the answer for my specific year model. Any help would be greatly appreciated). To clarify I have bought the original pmc bro water pump kit and original brp lower seal kit which should have all necessary seals between the 2 for the completion of the job. I have run into 2 problems. I will try to describe as best I can cause I do not know all part names etc... So far I have removed lower unit, propeller and water pump. I am cannot remove the the housing in front of the drive shaft where the shift rod sits in. I received a gasket for it but the gasket is for a longer housing with 6 screw holes where my model has a smaller housing with only 4 screw holes. That is the 1st problem. 2nd is that the shift rod to my knowledge cannot be unscrewed from the lower unit like most videos I've watched. Most videos say that models from year 73 to 77 is just unscrew the shift rod. Mine seems locked both right and left when I try to turn it. I am afraid to apply too much force. My lower unit is completely disassembled save for my shift rod and housing around it. I also dont have the proper gasket but that is the least of my worries cause j am sure I can find one fast. I believe I am able to reseal the entire lower unit but cannot do the housing around the shift rod since I do not know how to remove the shift rod. Can any one shed some light on the shift rod matter. That you in advance and sorry about my rambling.