shift issue and running with some noise from lower unit gear

[alldodge]

Your drive is to high, does it reduce when it's lower?

 

[liusigou]

Your drive is to high, does it reduce when it's lower

It Works perfect after I lower outdrive. Thaka you All Dodge

 

[alldodge]

Should never start or run that high, that was the U joints banging around

 

[liusigou]

Should never start or run that high, that was the U joints banging around

Thank you. Now there is not any noise from lower unit.

 

[liusigou]

Today I push a lot of greese through this hole, but I did not any greese. Was the greese push into gimbal bearing?

 

[Bondo]

Today I push a lot of greese through this hole, but I did not any greese. Was the greese push into gimbal bearing?

Nope,.... It'll pile up on the tiller arm, inside the boat,.....

The gimbal bearing fitting is 'bout 1/2 way down the starboard side,....

 

[liusigou]

Today I found the wire of the part is broken. Should I fix it? But it work as even the wire is broken

 

[alldodge]

It doesn't work correctly

 

[liusigou]

It is difficult to pull it out. How can I fix it?

 

[liusigou]

It doesn't work correctly

Help me please

 

[flashback]

Trim sensor or limitor, it's a pain to replace and isn't worth fixing but you can try...

 

[nola mike]

Help me please

Yes, it's difficult to repair. No, you don't need it. Seems like you have enough issues to take care of, I'd leave that one until you do your bellows. I haven't had a trim gauge or limit switch in years

 

[liusigou]

Yes, it's difficult to repair. No, you don't need it. Seems like you have enough issues to take care of, I'd leave that one until you do your bellows. I haven't had a trim gauge or limit switch in years

I have two mercruiser, I have given up the one that the third cylinder compressure is low. Now I continue working on the new boat which cylinders are good in compressures.

Current the new boat does not have the issue of bellows.
I will leave it if it is not necessary.

Thank you