Setting the timing on a 1997 4.3?

[etrump]

I have all the tools,Just need to know how to jump dist. so advance will not happen.
Delco ign / 8deg,otdc.

 

[etrump]

Re: Setting the timing on a 1997 4.3?

 

[Don S]

Re: Setting the timing on a 1997 4.3?

So, I take it you have an EST distributor and a carbed engine, is that correct?

 

[etrump]

Re: Setting the timing on a 1997 4.3?

Yes Don,EST. I have the online link you sent me in an earlier post.It's been a lot of help.Thank you again.
Boatinfo - Volvo Penta LK series Engines Electrical and Ignition Service Manual

 

[Don S]

Re: Setting the timing on a 1997 4.3?

The only problem with following the manual on timing the EST is because every manual Volvo has published is wrong, and they don't seem to be able to get it right. Have a look at this thread from 08.

http://forums.iboats.com/volvo-pent...drives/volvo-est-timing-procedure-271407.html

 

[etrump]

Re: Setting the timing on a 1997 4.3?


Went to the junk yard & got the wire off a 93 astro van.Little bit of soldering and bam.Timing is set.
Hope this help someone out there.
Set Timing as follows:
1. Start and run the engine until it reaches proper operating temperature.
2. Connect timing light to #1 spark plug wire.
3. Remove the blind plug (1) and install timing connector p/n 885163 onto distributor. Attach the alligator clip lead to a B+ source.

NOTE:
The Alligator clip lead of the Initial Timing Connector must never be connected to a B+ source until after engine is started. This is necessary to avoid damage to the electronics of the ignition system.
When the B+ source is connected, the engine may reduce RPM. If engine stalls and must be restarted the lead to the B+ source must be disconnected.