Resistor wire

[corytha]

Thank you.

 

[corytha]

Undo the resistor wire terminal from the coil. Don’t cut it. Coil or fold the resistor wire, which is now loose, back to a convenient location and zip tie it to something. You might want to reconnect it back some day. A few wraps of electrical tape over the bare terminal would be good.

I did that and the motor wont start. So i put it back.

 

[Candy Gramformongo]

I did that and the motor wont start. So i put it back.

OK, I have kind of lost the plot as to what your problem is. But I think I should ask what did you use to supply 12V to your coil after you removed the resistor wire?

 

[corytha]

Where should I add a wire to for the 12v

 

[Candy Gramformongo]

choke
or
new wire from ignition switch

 

[corytha]

choke
or
new wire from ignition switch

Okay thank you.

 

[corytha]

choke
or
new wire from ignition switch

From the ignition run position?

 

[ROY WILLIAMS]

choke
or
new wire from ignition switch

the key on engine starter ignition coil +12volts .....the engine on key switch on , 9 volts of the wire 1.8 ohms resister of the choke - resister ignition coil positive +.... 9 volt...