Replacing V4 Johnson/Evinrude Thermostats.

James R

Commander
Thread starter
Joined
Feb 1, 2007
Messages
2,681
These have always been a wrestling match for me, trying to hold the housing whilst compressing the springs and starting the 1/4 bolts. Using rubber bands to hold the assembly together works great but holding the assembly against the springs is a pain. This time I removed the lower cover lower skirt to give me access from below. I then pressed the housing against the springs and slid two wooden door framing shims up from below each side of the center screw holding the housing in place against the spring pressure. This allowed enough movement to locate and start the center screw. With that screw located the other two are straight forward.
A dog legged 7/16 ring wrench is a must for doing this job.
I acknowledge that I am probably not the first to use this method but I did not find this helpful piece of information anywhere.
Hope someone else finds this helpful.
 

sutor623

Rear Admiral
Joined
May 23, 2011
Messages
4,089
Thats funny I have never had an issue with these........ I suppose you could get a longer 1/4" bolt and thread it in to hold everything in place, then compress the spring and put the smaller screws in the other holes.
 

sutor623

Rear Admiral
Joined
May 23, 2011
Messages
4,089
Ahhhhh, you are talking about the crossflow motors. In that case, YES, the "homemade" wrench goes a long way. I know a few guys on here that have drilled holes into their lower motor covers to access the stats, and then just put rubber plugs into the holes. The key is to get the plug AND THEN drill the holes :)
 

Brock O

Seaman
Joined
Dec 26, 2014
Messages
60
I couldn't manage solo, but i do have hands like dinner plates!

Used too butter knives from the kitchen up and under to hold the housing in place and a second set off hands to get the bolts started.....very slow process bolting up due to room.

absolute pain in the ass....almost easier to disconnect power head...lol
 

James R

Commander
Thread starter
Joined
Feb 1, 2007
Messages
2,681
The wedge shape of the construction shims holds the housing in place so you can let it go and even take a beer if you want. Use OMC gasket seal on the threads. This will protect the bolts from corrosion in case of a next time and provide a little lubrication. Start the center bolt with fingers and then wrench. Leave loose. Make sure you don't cross thread. Then locate the two outer bolts. Remove the rubber bands before pulling the bolts down evenly. Dog leg ring wrenches are still available, do your research. A 1/4 drive socket will do the center bolt.
Those of you that have very strong fingers and those that have two pair of hands may find it easy without this technique . The wood shims and rubber bands make it simple. Try it you'll like it.
 
Last edited:
Top