Replacing Impeller on a 6 hp Johnson Seahorse

WaterLog

Recruit
Thread starter
Joined
Jun 27, 2003
Messages
1
When I recieved this outboard to guy said all it needed was an impeller. The Model # is 6R79E Serial # I5097952. Honestly I am not sure if the "I" in the seriel # is not a "J". <br /><br />I was also told that you could just take the last to digits of the serial # and know that this is the date. That would make it a 1952 year model. However I read some of the post that ask the year to thier outboards and this was not the case. So if someone knows what year this is I would really appreciate it. <br /><br />I would like to get this baby rolling and would ask for any advise on how to start replacing the impeller. I will probably replace the water pump while I am at it. I have heard that they are close together and neither is very expensive. Thank you in advance for your advice.
 

Solittle

Fleet Admiral
Joined
Apr 28, 2002
Messages
7,518
Re: Replacing Impeller on a 6 hp Johnson Seahorse

WaterLog - First welcome - Lots to learn here. <br /><br />As to the waterpump - the impeller is part of the waterpump - it is made of rubber and goes inside of the pump. My suggestion is when you first get a motor that you replace the entire pump (a shop manual helps). After that replace just the impeller every couple of years. If you have a V4 or V6 it is a good idea to install a water pressure guage and monitor pressure. It will tell you the condition of the impeller over time.
 
Top