VineyardBayliner
Recruit
Thread starter- Joined
- Jul 23, 2008
- Messages
- 3
Hey guys!
This is my first post. I just bought a 2003 Bayliner 1950 Capri last week this is immaculate. I decided to change out the factory tape deck to a new Sony with the built in ipod control. The factory Bayliner harness has 8 wires total, power and ground then 6 speaker wires front left and right positive, rear left and right positive, then just 2 negatives- Left and Right. I'm used to car audio. I've never not seen each speaker have it's own power and ground. Now my problem. The sony has the 12 volt accessory wire (yellow) and orange (illumination) where should I be hooking these up? I don't want to have to leave the engine ignition on for the radio to be on. I tried hooking it up without the yellow wire connected and there was no power. Any suggestions is highly appreciated.
Tom
This is my first post. I just bought a 2003 Bayliner 1950 Capri last week this is immaculate. I decided to change out the factory tape deck to a new Sony with the built in ipod control. The factory Bayliner harness has 8 wires total, power and ground then 6 speaker wires front left and right positive, rear left and right positive, then just 2 negatives- Left and Right. I'm used to car audio. I've never not seen each speaker have it's own power and ground. Now my problem. The sony has the 12 volt accessory wire (yellow) and orange (illumination) where should I be hooking these up? I don't want to have to leave the engine ignition on for the radio to be on. I tried hooking it up without the yellow wire connected and there was no power. Any suggestions is highly appreciated.
Tom