Replacement Ladder

[Gino27]

My Stingray 180LX has a 2 rung Windline ladder on the rear platform that I'd like to replace with a 3 or 4 rung. The original ladder had holes that are 12" center to center, and I can't seem to find any ladders that aren't either 10" or 14" center to center. Do you all know of any ladders that would fit my spec, or should I just fill the existing holes and make a bracket to cover them up with a narrower ladder?

 

[Grub54891]

It's hard to find a ladder to fit the current setup. The mfg change the designs as often as we change our underwear.

 

[Scott Danforth]

boat hardware is bought from an NMMA consortium of parts. some are from ASG (attwood/garelick/etc), some from off-shore sources.

many of the ladders that were available last year may not be available this year.

 

[tpenfield]

Shop similar brands, (Amarine, Attwood, etc.) to see if you can find a fit. Lots of online products don't show enough of the dimensions to make a proper choice.

If the holes are 12" apart on-center, then the ladder is probably advertised as a 14" ladder (perhaps)

 

[Gino27]

Shop similar brands, (Amarine, Attwood, etc.) to see if you can find a fit. Lots of online products don't show enough of the dimensions to make a proper choice.

If the holes are 12" apart on-center, then the ladder is probably advertised as a 14" ladder (perhaps)

I haven't been able to find anything listed as 14" or with 12" hole separation. Thinking I'll just have to make a plate to cover the holes and drill fresh.