Repairing a MinnKotta trolling motor

Super55

Recruit
Thread starter
Joined
Oct 14, 2008
Messages
2
The height adjust tab on my brother in law's trolling motor broke off. I think it was the cold weather made the tab brittle. Anyhow, I have a new tab coming in the mail, and was wondering if there is a schematic for a 38# thrust model. I don't have the model number. I was wondering if there is a schematic anywhere on the net that shows an exploded parts view. When I looked at it, the tab has a metal shaft that it rocks on, with the spring assembly below. Taking out the metal shaft does not release the tab, it is attached to the spring mechanism. Do I have to take apart the transom mounting assembly by removing the large pivot pin, to get to the spring mechanism and somehow release the tab?
 

rndn

Commander
Joined
May 20, 2007
Messages
2,323
Re: Repairing a MinnKotta trolling motor

Welcome to the iboats.com boating forum!!:):)
Try the manufacturers web site with the model number. Also post the model and serial number here so if someone does have the manul they can try to help you out.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Repairing a MinnKotta trolling motor

Are you talking about the device that allows adjustment of the motor shaft vertically or are you talking about the tilt locking mechanism which allows tilting the motor at an angle? Pictures sure would help, especially when there is a parts description issue.
 

Super55

Recruit
Thread starter
Joined
Oct 14, 2008
Messages
2
Re: Repairing a MinnKotta trolling motor

Unfortunately, I am about 200 miles from the motor, but I will email my brother in law for the info. It is the piece that adjusts the vertical shaft. There is a small pin that holds the piece that needs replacing, but there is the spring mechanism that is attached to the piece that needs to be replaced. Looks like the tilt adjusting mechanism has be taken apart to get it out. It has about a 3/8" shaft that it pivots on.
 
Top