Red RTV Gasket maker for Johnson 15

thatone123

Banned
Thread starter
Joined
Mar 7, 2009
Messages
707
Seems race one has even lengthened his spark to 3/8's now. With the typical enclosed chamber spark tester that shows an orange spark, you can't even see how long it is. "Sorry. just had to say it"
 

thatone123

Banned
Thread starter
Joined
Mar 7, 2009
Messages
707
Oh, well, Thumb, seems I won't get that far as I can't start the engine. It is still tight enough that it won't spin fast enough by the manual started cord. I have tried with an air wrench but it just won't create the torque and either will a typical 3/8 drill. Any ideas anyone? The difference between me and some others is I don't care if some don't agree with me or even if I look uninformed or naïve as that is how we learn, and it serves the purpose of the forum if others learn from my mistakes!
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
You appear to scoff at factory test methods that have been used by shops for over 50 years.-----Not all of us use the " crank and hope " repair methods.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
If you cannot turn the motor over with a drill or or an air impact (which is a horrible idea anyway) you have a serious issue with your motor. You need to to tear it back down to determine the cause of it being so tight. Are all the locating dowels on the bearings lined up correctly. If it does start at all and being so tight it will wreck itself anyway.
 
Last edited:

Cadillac-ack-ack

Petty Officer 2nd Class
Joined
Dec 1, 2017
Messages
104
Anyway I gave up on the motor as it was too tight to turn over and then 2 weeks later got the bug to try it again. I tried every way on earth to match those parts and finally got it assembled to where the crank turns lightly and I hope it does not destroy it's self after I start it. lol

What happened with the crank turning OK? As per your initial thread, I have a feeling that the con-rods and caps were miss-matched from the start and by assembling them this way damaged the very delicate microscopic surface that results when the rod/cap is separated by fracturing. This would mean that even though the correct caps are on the right rods now,the assembly does not mate well and binding results. Think of it this way, forcing a course threaded nut on a fine threaded bolt will result in damaging both parts to the point that you'll never get the right nut on the right bolt again. Very real possibility the needle bearings are damaged too as well as the crankshaft. If it were me, and not feeling too discouraged, I may consider putting this engine aside, taking what I've learned, and applying it to one of those other 15's. You can use this one for reference. - Pete
 

thatone123

Banned
Thread starter
Joined
Mar 7, 2009
Messages
707
Pete, yes, as I said in the past, I had given up on this outboard weeks ago, but came back. Well, so much for that. Yes, I think I will save this motor for parts. If It wasn't winter and not a lot to do, I never would have tackled this anyway. I think you are right that it is in general screwed up now, live and learn, I always say. I can probably clean a carb on these or put in a water pump in the dark, but engine rebuilding must not be my huckleberry. I just read an article where the guy said that the new outboards are almost being made where you cannot repair or rebuild them. Corporate wants the folks only to be able to buy new ones.
 
Top