SevenBoater
Cadet
- Joined
- Oct 5, 2020
- Messages
- 10
Hi, hoping for a little advice regarding my carburetor rebuilds. I am rebuilding the carburetors on my 1985 Mercury 50 hp two-stroke using QuickSilver kits part number 1395-9023. The top carb is stamped WMA3.1. The rebuilds have gone well so far with one exception. The kits have one less gasket than what was present in the carburetors. Specifically there was a very thin gasket between the pump diaphragm and the fuel pump body. I have attached a photograph with an arrow pointing at the extra gasket. My Clymer manual does not show this extra gasket. So.... should I re-use the old gaskets or should I install just the gaskets and diaphragms that came in the kits?
Thanks in advance for your help.
Unfortunately, when I try to upload the picture I get an error message.
Thanks in advance for your help.
Unfortunately, when I try to upload the picture I get an error message.
Last edited: