rebuild question

[longboard85]

Hello i have a 1996 evinrude 70 hp engine that i am in the process of rebuilding. I was wondering where the best place to buy a powerhead rebuild kit would be. I am going to have the cylenders bored and honed so the pistons will need to be oversized any help would be appreciated. thanks

 

[Barnacle_Bill]

Re: rebuild question

Right here at i-Boats http://www.iboats.com/Evinrude-Powe...2311068--session_id.956968921--view_id.269082

 

[longboard85]

Re: rebuild question

Thank you but i dont see what i need for a 3cylinder that is in my year range. any other suggestions would be great.

 

[Johny25]

Re: rebuild question

Try this site....... #100 is what I think you want on the diagram. http://www.**********/parts/search/BRP/JOHNSON/1996/BJ70ELEDA/CYLINDER & CRANKCASE/parts.html

Or this site also #100.... And I would strongly recommend paying the extra and getting the OEM J/E set and not the Sierra http://www.marineengine.com/parts/j...rer=Evinrude&section=Cylinder+&+Crankcase

 

[durban]

Re: rebuild question

I would replace exhaust gaskets while you at it .

 

[Haffiman]

Re: rebuild question

I would replace exhaust gaskets while you at it .

Included in the P/H gasket kit.

 

[Johny25]

Re: rebuild question

Not sure why my post link got edited or covered over, but the first link was to ********** and the second was Marineengine.com. Did I violates some rule on here by posting a link to another site?

There it goes again WTF?...........b o a t s . n e t..............is the site that is being blocked