reassembling prop shaft on 1981 2 hp evinrude

so

Petty Officer 2nd Class
Thread starter
Joined
Feb 12, 2007
Messages
170
in the process of trying to restore this old outboard. working on the lower unit today, the prop shaft unit was sealed pretty tight, had to pull hard to get it out and a small gear popped out with it. the problem is now I dont have a reference as to which way it goes in and how it fits together with the bigger gear. see pics.

can anyone give me some pointers. thanks.
and what's the part number for the seal (the big o ring)
 

Attachments

  • photo291189.jpg
    photo291189.jpg
    152.4 KB · Views: 1
  • photo291190.jpg
    photo291190.jpg
    175.7 KB · Views: 1

so

Petty Officer 2nd Class
Thread starter
Joined
Feb 12, 2007
Messages
170
ok, I figured out how the gears fit together.
question, after I clean off the parts with carb cleaner, should I lube the inside of the housing(pic 2) with anything?
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
You lay the motor on its side with the fill plug pointing up. Add hi-vis marine oil until full, then put the plug back with a new washer.

Oh, and you need a new pump impeller - that one's toast.
 

so

Petty Officer 2nd Class
Thread starter
Joined
Feb 12, 2007
Messages
170
You lay the motor on its side with the fill plug pointing up. Add hi-vis marine oil until full, then put the plug back with a new washer.
.

thx. I know I'd need to refill with 90w gear fluid after I reinstall the gear case. I was just wondering while I had it out, do I need to lube the inside with anything else.
 

Lightwin 3

Petty Officer 1st Class
Joined
May 18, 2010
Messages
300
Adding the lube will take care of it.

Not 90 W. Use OMC/BRP "Hi Vis". While you're at it, replace the fill plug seal.

Also, you may have to do some hunting to find those missing imeller blades. And replace the impeller.
 
  • Like
Reactions: so
Top