reassembling crank case question on adhesive

rodknee1231

Petty Officer 2nd Class
Thread starter
Joined
Jul 28, 2015
Messages
136
so I have a 1973 135 hp I'm re assembling the crank case the service manual calls for omc m adhesive which is no longer in service everyone says use gelseal or some 3m stuff is that right? and I do put the adhesive on the actual smooth metal mating surface correct?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Your engine uses a spaghetti seal between the two crankcase halves in 1973. There is a groove cut in the face of the block to accept those seals. I would not use gelseal only on that block. I would replace those seals so it's just like it was in 1973. Part number: 314964. 2 pcs. The original factory service manual stated to use the M sealant. Not sure just what 2015 sealant would be recommended, but it's possible gelseal would work in combination with the two seals. Later engine blocks did away with that spaghetti seal and switched to the Gelseal exclusively.
 

rodknee1231

Petty Officer 2nd Class
Thread starter
Joined
Jul 28, 2015
Messages
136
I know I need the spaghetti seal and some sort of sealant I'm not sure where exactly the sealant goes if it's only on the seal or on the face as well
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
This a precision joint.-----Make sure surfaces are absolutely clean.-------Use loctite 518 or gel seal the face of the block.---------Using a sealer with too much " filler " can result in too thick a film.-------That would mean poor clamp-up of the bearings.
 
Top