Rear Main Seal 230A

fritzdfk

Recruit
Thread starter
Joined
Jun 19, 2011
Messages
2
I had a serious oil leak that I was sure was coming from the rear main seal. The engine is one of the 4 cylinder overhead cam versions. I replaced the seal and the leak is just as bad. I have also replaced the oil pan gasket and replaced the seal plate gasket. So I either did a bad job replacing the seal or the oil is coming from somewhere else. I didn't have the special seal tool but was very careful in placing the new seal in slightly further in than the old one as there was barely discernible scoring where the old one was. The oil is dripping from the bell housing and being thrown around by the flywheel as the cover plate, covering the lower portion of the flywheel, is missing. Before I pull the engine again I thought I would ask for advice, maybe there is something I am missing.
 

cc190cc

Petty Officer 2nd Class
Joined
Jan 17, 2010
Messages
198
Re: Rear Main Seal 230A

is there an oil pressure sensor or something on back side of engine that could be leaking down the back. I know on my chevy 350 the oil sensors are on the backside by the bell housing. Also is there any chance it is coming from headgasket and leaking down. I have no idea what engine you have based on 4 cylinger overhead cam, is it a chevy motor?? When you did the oil pan gasket were you sure to get all of the old gasket off?? does the leak seem to have pressure behind it or is it just dripping??

Chad
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Rear Main Seal 230A

When you get the engine out, pull the flywheel cover, and the flywheel. There is a core plug for the auxiliary shaft that may leak, there are also a couple of set screws that may have rusted or something. Was there a lot of rust inside the housing before? Is rust what took out the original seal?
 
Top