lister
Petty Officer 2nd Class
- Joined
- Jun 29, 2015
- Messages
- 141
I'm about to install my Alpha one gen 1 sterndrive back onto the boat.
Gasket surfaces clean
Shift parts greased
bolt threads cleaned
grease holding the water inlet gasket in place
A little grease holding the exhaust bellows in place (the top big one whatever that is - shift bellows?)
replaced the two rings on the outdrive shaft
Torque wrench ready at 50 ftllbs
Anything else?
** most importantly** Also once done is there a way to test its waterproof other than taking it to the lake?
I dont want to spray high pressure water into the gimbal etc really but would love to know its water proof before putting it into the lake
Gasket surfaces clean
Shift parts greased
bolt threads cleaned
grease holding the water inlet gasket in place
A little grease holding the exhaust bellows in place (the top big one whatever that is - shift bellows?)
replaced the two rings on the outdrive shaft
Torque wrench ready at 50 ftllbs
Anything else?
** most importantly** Also once done is there a way to test its waterproof other than taking it to the lake?
I dont want to spray high pressure water into the gimbal etc really but would love to know its water proof before putting it into the lake