So I am nearing the point that I will be testing my pair of 150's tomorrow. Ive picked up a portable tank, plan is to use this to test while I continue to flush and change all racor filters on inboard tank.
Here are my questions that I could use some guidance on.
1. Where is the best/easiest place to plumb the portable tank into on the engine, they are Evinrude Ficht 150's.
2. Should I premix 50-1 with xd50? They have been sitting for 2 years, so I want to make sure they are getting lubrication. I've already refogged cylinders by removing plugs. They have been soaking for a day. Plugs are indexed and gapped .028.
3. Should I change/pump out old injection oil? Again been sitting a while. Not sure if it will hurt if I have that running along with premix?
I will be changing out plugs after initial run and will be putting back into break in mode for bit.
Thanks in advance.
Jeff
Here are my questions that I could use some guidance on.
1. Where is the best/easiest place to plumb the portable tank into on the engine, they are Evinrude Ficht 150's.
2. Should I premix 50-1 with xd50? They have been sitting for 2 years, so I want to make sure they are getting lubrication. I've already refogged cylinders by removing plugs. They have been soaking for a day. Plugs are indexed and gapped .028.
3. Should I change/pump out old injection oil? Again been sitting a while. Not sure if it will hurt if I have that running along with premix?
I will be changing out plugs after initial run and will be putting back into break in mode for bit.
Thanks in advance.
Jeff