PUZZLED Changing solenoids on PTT

Redneckerson

Recruit
Thread starter
Joined
Apr 10, 2009
Messages
2
I picked up a 1985 Johnson 115 a while back. It kept burning up relays to the power tilt/trim(probably due to the way the wires were rigged)Anyhow I am trying to replace them with two solenoids I took off a OMC unit. These are round with 3 posts (2 big and 1 small) I mounted them to a plate grounded to the neg post on the battery, hooked power from battery to one post then to the second in series. I have the blue/green trim wires to the motor hooked to the other big post and the switch wires hooked to the small posts.They will click but not run the motor. If I have disconect the trim wires one at a time and ground one while I press the switch it works, I evidently am missing a ground somehow, Can anyone help, Thanks
 

Splat

Lieutenant
Joined
Jul 20, 2008
Messages
1,366
Re: PUZZLED Changing solenoids on PTT

Ummmmm...... Let me try to explain this,

Your old relays should have had 4 wires going to them. Constant power in, this will go to a large post on each of the solonoids.

Then accessory or switched power out, this will go to the other large post on the solenoid respectively.


Then the switch power , or coil wire coming in(from the trim switch) will go to the little terminal on the solenoid, again respectively to how they were attached to the original relays.

Lastly the ground wire can be discarded since you have them mounted to a grounded plate, thus completing the electrical field allowing the magnet in the solenoid to actuate.

Hope this helps, your description is a little hard to follow without being able to see how it was originally wired.

Bill
 

Redneckerson

Recruit
Thread starter
Joined
Apr 10, 2009
Messages
2
Re: PUZZLED Changing solenoids on PTT

10-4 Thanks, I did have it wired like that but it would only operate with one of the trim motor wires (2wire motor)grounded at a time(oposite ofthe one recieving power).If I ground both terminals it shorts the system.I'm sure it's a simple fix but there's something I'm not seeing. Thanks again for the help.
 
Top