pull cord problems

[bobcat21]

I just recently purchsed a 15 hp chrysler seaking outboard, the gear on the pull cord that engagues to the flywheel was busted, got a new one and put it on now i need to know how to rewind spring.can someone help? also can you tell me what year model this outboard is? model # is VWB52119C. any help will be appericated.

Thanks.

 

[Frank Acampora]

Re: pull cord problems

There is a special tool that makes it easy but you can improvise. On top of the rewind is a screw. remove this and slide out the pin holding the pinion gear. NOW install the new pinion. Take a LONG 10-24 screw with an allen head socket. Run a nut partially up the screw and run the screw into the rewind. Only run the screw in about 1/4 inch so the pin can be replaced. Jam the nut down hard to keep the screw from turning. Now rewind the spring with an allen wrench. When it is tight enough, slip the pin back through the pinion and shaft. install the original screw to lock the pin in place. If the cord does not retract fully, repeat the process. Do not over tighten or the cord will not have full pull.

Ten minute job!