Propeller shaft bearing housing removel

rathwell0327

Recruit
Thread starter
Joined
Jul 26, 2009
Messages
2
I have a 1975 Johnson 70HP OB motor. Does anybody know if the propeller shaft bearing housing just slides of the propeller shaft. I also see that there is two threaded holes on the bearing housing. I am assuming that these two holes are used to remove the housing.
 

jtexas

Fleet Admiral
Joined
Oct 13, 2003
Messages
8,646
Re: Propeller shaft bearing housing removel

correct. Use the two threaded holes with a gear puller. it's a tight fit, heat may be required. use extreme caution when heating the gearcase.

Note there are two hex head screws down in there holding the bearing housing in place. you'll need a long socket extension. The rubber o-rings on those screws should be replaced. You can use a couple lengths of allthread screwed into these two holes to align the carrier while you press it back into place.
 

lolo64230

Cadet
Joined
Jun 5, 2009
Messages
14
Re: Propeller shaft bearing housing removel

Hi,

I'm in the same case. I'vz made a puller fixed in the 5/16" threaded holes, but the bearing housing doesn't want to come. I'va also tried by heating the gearcase but it is the same. Do somebody have a solution?
Thanks
 
Top