Problems with wiring on Quicksilver 2000 Remote

[Da_Frigifration_Man]

Hey guys, new to the forum, but a long time fan. Good stuff here...........

Anyways, i have a question about my Quicksilver ?Commander? 2000.

The plug for the instrument panel, what do the wires go to? I have a tach already hooked up, but the boat set up for a while and, well long story short because of my parent's neglect, I am redoing the deck in the boat and doing some other long needed TLC.

Anyways, I have a brown and white wire coming out of the harness for the instrument panel but apparently a rat or squirrel got a hold of it thinking it was an acorn and chewed it. It does not have PTT and from what i could tell that may be for it or a gauge for the PTT or something............... ANY light shed on this would be very helpful.

Thanks..
Steve

 

[carholme]

Re: Problems with wiring on Quicksilver 2000 Remote

Steve;

Brown with a white stripe is the trim sender to the trim gauge and if you are not using it, cap the end and fold it back into the harness.

Gerry

 

[Da_Frigifration_Man]

Re: Problems with wiring on Quicksilver 2000 Remote

Ok, that's what i was thinking, was just wanting to confirm.

Thanks much Gerry.