Problem with Johnson Touch Trim

bhilliar

Recruit
Thread starter
Joined
Aug 9, 2003
Messages
1
I have a 50HP '95 Johnson. The motor goes down but does not tilt up. On enquiring from our local dealer, I was told that I need a complete new trim hydraulic unit as they tell me that it CANNOT be repaired - the service manual also warns that this unit should not be tampered with.<br /><br />1. Is this true or can it be serviced?<br />2. If I do require a new unit, where can I do so over the net as our local supplier is a rip off?<br /><br />Many thanks
 

OBJ

Supreme Mariner
Joined
Dec 27, 2002
Messages
10,161
Re: Problem with Johnson Touch Trim

Bart....if you have a service manual, go to the section that explains the procedure for adjusting the little handle that operates the cylinder. May be just out of adjustment or look at were the cable connects to the handle. There is a plastic connector that breaks pretty easy. This in inside the transom mount brackets where the assist cylinder sets. Let us know what ya' find. Thanks.
 

robban

Recruit
Joined
Aug 7, 2003
Messages
3
Re: Problem with Johnson Touch Trim

I had a similar problem with my 50hp '90, it was cured by adjusting the cable. I think the Touch Trim system sucks - I´ve never been able to lift the motor without using muscles! Is there anybody who knows how to use the bloody system correctly?
 
Top