just want to say thanks to those who responded to my thermostat question the other day...
going to order a new one to be safe...
i have the motor on a stand with the powerhead out and i want to tilt it up so i can change the water pump...
again my manual does not help with the unit that has no eletrical hooked to it..
dont want to start bleeding lines at this point but i am wondering if just remove a bolt or two so i can get clearence..
if so what bolts should i be looking at?
i see 2 on port side, but the pump is on the starboard side and i don not want to remove it
thanks so much
glenn
going to order a new one to be safe...
i have the motor on a stand with the powerhead out and i want to tilt it up so i can change the water pump...
again my manual does not help with the unit that has no eletrical hooked to it..
dont want to start bleeding lines at this point but i am wondering if just remove a bolt or two so i can get clearence..
if so what bolts should i be looking at?
i see 2 on port side, but the pump is on the starboard side and i don not want to remove it
thanks so much
glenn