Popping out of gear trouble/help

Jswails

Recruit
Thread starter
Joined
Sep 11, 2018
Messages
3
so story goes I was going flat out and it popped out of gear so I throttled down and shifted into neutral. Shifted back into forward and got reverse shifted reverse got reverse. Clutch dog had been popping in and out as well. Tore lower unit off to find the shift yoke had broke. So replaced shift yoke and the clutch dog forward rev and pinion gear all looked to be in good condition. Get it all back together and it’s still popping out of gear. What could this be? What else is there to check besides linkage. It’s a 1981 evinrude 35hp e35elcig.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
I would guess the broken shift rod was a symptom not the problem. But you could have the shift rod misadjusted but if not.. Those lowers are not known as the most robust. The main problem was probably the clutch dog and gear being bad. The shift shaft broke when it jumped out of gear.
 

Jswails

Recruit
Thread starter
Joined
Sep 11, 2018
Messages
3
Shaft never broke just the yoke that cradles the Phillips screw. And how do you get the shaft mid adjusted
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
sorry read the shaft broke. You have a bad clutch dog and gear pretty common on them.
 

Jswails

Recruit
Thread starter
Joined
Sep 11, 2018
Messages
3
I had just replaced the clutch dog while I was replacing shift yoke. And the gears didn’t show any signs of wear.
 

juno pierrat

Petty Officer 1st Class
Joined
Dec 14, 2013
Messages
355
is the shift rod height correct, very tight adjustment usually +/- 1/32. Is your engine tiller or remote shift?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
I do not believe shift rod height applies to this engine..
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
so story goes I was going flat out and it popped out of gear so I throttled down and shifted into neutral. Shifted back into forward and got reverse shifted reverse got reverse. Clutch dog had been popping in and out as well. Tore lower unit off to find the shift yoke had broke. So replaced shift yoke and the clutch dog forward rev and pinion gear all looked to be in good condition. Get it all back together and it’s still popping out of gear. What could this be? What else is there to check besides linkage. It’s a 1981 evinrude 35hp e35elcig.

There is no shift rod measurement on this 1981 35hp model. It's a locked measurement in the connection behind the water intake screen.

The clutch dog has grooves on one face... those grooves must face forward gear, otherwise the unit will guaranteed jump out of gear. Sounds like you may have installed it backwards.
 
Top