leftseat150
Cadet
- Joined
- Feb 21, 2010
- Messages
- 8
I'm replacing the driveshaft on my J60TLCRE. It is an 84 model. I'm wondering if there is an alternate method of shimming the pinion gear other than using omc special tool 320739 or 393185 as outlined in my factory service manual. If I simply had the dimension of the tool, I could use my caliper to arrive at the correct height. I'm thinking of just setting up the new one with the same measurement as the old one. I was hoping the 70$ manual would give me this specification. When I worked at an automobile dealership, we had alternate methods of doing things, I'm sure there are some for lower unit's as well.
May your coolers be full of fish, and your outboards humming a song!!
May your coolers be full of fish, and your outboards humming a song!!