Overheating at 30mph

Lou C

Supreme Mariner
Joined
Nov 10, 2002
Messages
12,653
Ah saw that it was rebuilt; so the shop must have boiled out the block & heads
 

QBhoy

Fleet Admiral
Joined
Mar 10, 2016
Messages
8,342
I think it’s worth checking that impeller again. Doesn’t take much to ruin them quickly. Especially if you had an attempt at running her on the muffs and hose before putting her in the water. Can be a 50/50 if these will pull water up from some muffs.
 

Galvez83

Petty Officer 1st Class
Joined
Oct 31, 2019
Messages
279
The new impeller has been ordered since its cheap insurance i rather just knock it out. Then while there, review all hoses and hose clamps. Who knows, i might get lucky with it and ends up beign a loose hose.
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
49,537
The new impeller has been ordered since its cheap insurance i rather just knock it out. Then while there, review all hoses and hose clamps. Who knows, i might get lucky with it and ends up beign a loose hose.
nah.....

the typical locations for air ingress on a generic volvo installation are the casting on the drive, the seals on the raw water pump, the cover on the raw water pump, the swivel seals on the drive.

a clear hose between the raw water pump and the rest of the down stream engine is vital for troubleshooting. if you see bubbles, you have an air leak.

to get more specific on other possible ideas of overheat, we need to know which cooling system etc. is on your boat.

have you back-flushed the power steering cooler for debris as this cooler is usually plumbed between the pickup and the raw water pump

overheating is simply a lack of raw water flow and going thru the system to check what may be causing low flow.
 

Galvez83

Petty Officer 1st Class
Joined
Oct 31, 2019
Messages
279
nah.....

the typical locations for air ingress on a generic volvo installation are the casting on the drive, the seals on the raw water pump, the cover on the raw water pump, the swivel seals on the drive.

a clear hose between the raw water pump and the rest of the down stream engine is vital for troubleshooting. if you see bubbles, you have an air leak.

to get more specific on other possible ideas of overheat, we need to know which cooling system etc. is on your boat.

have you back-flushed the power steering cooler for debris as this cooler is usually plumbed between the pickup and the raw water pump

overheating is simply a lack of raw water flow and going thru the system to check what may be causing low flow.

nah.....

the typical locations for air ingress on a generic volvo installation are the casting on the drive, the seals on the raw water pump, the cover on the raw water pump, the swivel seals on the drive.

a clear hose between the raw water pump and the rest of the down stream engine is vital for troubleshooting. if you see bubbles, you have an air leak.

to get more specific on other possible ideas of overheat, we need to know which cooling system etc. is on your boat.

have you back-flushed the power steering cooler for debris as this cooler is usually plumbed between the pickup and the raw water pump

overheating is simply a lack of raw water flow and going thru the system to check what may be causing low flow.
Engine is raw water cooled. I backflushed from water pump incoming water hose. I opened the cleanout on the outdrive and nothing came out prior to this event. Engine 5.7 dp-sm
 

Horigan

Senior Chief Petty Officer
Joined
Jun 12, 2016
Messages
673
Have you checked the water inlet on the drive, item #9 in post #7? If that's cracked that can lead to your symptoms.
 

Galvez83

Petty Officer 1st Class
Joined
Oct 31, 2019
Messages
279
Have you checked the water inlet on the drive, item #9 in post #7? If that's cracked that can lead to your symptoms.
Last i checked upon install it was in good condition. I ordered one just to have peace of mind.
 

Donald0039

Chief Petty Officer
Joined
Jun 11, 2022
Messages
402
I am read some people have by mistake reversed the raw water hoses and that causes issues. My two hoses are slightly different diameter so they cannot be reversed.

Pull thermostat and double check in pan of hot water. Hang by a string.

IR thermometer will be very beneficial for diagnosis. Once you get this straightened out take temps of manifold and riser and write in journal for future use.

Some rig up some clear hose in line with the hose from outdrive to raw water pump to see if it's full of water or has air pockets.
 
Top