Overheating and combustion, 115 hp Johnson

phedeen

Recruit
Thread starter
Joined
Sep 19, 2016
Messages
2
Had a spirited ride yesterday. Upon returning my overheating alarm went off. Docked. Checked engine. Intakes were clear. Good strong water exit stream (had water pump impeller replaced this year). Noticed some unburned fuel/oil coming out of one exhaust port and also beneath carburetor. Related? Can a carburetor or combustion problem cause a heating problem? Or just a cooling problem plus a carburetor problem?
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Doubt there's anything related about the unburned fuel/oil out the exhaust port, and the stuff under the carb may be a leaky carb fuel bowl or hose. Look there for leaks.

Did the overheat alarm come during low speed/no wake running?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
An overheat warning is just that. The engine is too hot. The overheat warning sounds when the engine gets over 212 degrees. (143-155 is normal idle temp.)
So you need to resolve the overheat first. You can have a strong impeller and telltale flow, and still overheat one (or both) heads. If the small holes in the valve body in the stat housing plug up with dirt, sand, debris, warm water can't get to the back of the stats to heat them open, you will get an overheat at idle. (you could even have a stat frozen shut.) Both of those problems result in a possible overheat.
 

phedeen

Recruit
Thread starter
Joined
Sep 19, 2016
Messages
2
Thanks to both responses above. Yes, I was idling along in the channel, no wake, almost to the dock, where I shut it down and rechecked. I will have to check both stats.
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Bleed holes probably, but if you're taking it apart, a thermostat kit would make sense for the cost.
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
I drill the bleed hole much wider so its much more unlikely to get blocked. When that hole blocks the water doesnt flow so the thermostat doesnt open, its quite a weakness to the system
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
^With larger bleed holes, have you ever noticed it idles any cooler than with the OE size? It may be my paranoia, but I thought mine was running colder with enlarged bleeds and when I put another OE spacer back it idled warmer. YMMV
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
^With larger bleed holes, have you ever noticed it idles any cooler than with the OE size? It may be my paranoia, but I thought mine was running colder with enlarged bleeds and when I put another OE spacer back it idled warmer. YMMV
Nothing that ive noticed nor being told about by the owners, it was my friends motor i enlarged the hole on about three years ago and its being running great ever since.
I would imagine that if the extra sized hole enabled more cooling water through then the thermostats would not open up so much which would thus in a perfect world keep things constant.
I just remember seeing the bleed hole being about the size of the ballpoint on a pen, so i thought where he was launching in a silty area, that that holes small size isnt going to be anyones friend
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Probably paranoia then. After installing the plate with enlarged holes, I was running it in a barrel and my IR temp gun showed the heads at less than 120F. Cold city water in the barrel, maybe 60F. It runs about 130F on the lake. I'm happy.
 
Top