Outboard revs in neutral itself

Mingog80

Recruit
Thread starter
Joined
Nov 24, 2015
Messages
3
Hi,

I have a 1992 Johnson 150 V6 outboard and the problem is that rev itself in neutral, its an itinerating failure.

This is a video with the failure:

https://youtu.be/nxov3-sCgM8


Thank you.
 
Last edited:

Roberthill

Petty Officer 1st Class
Joined
Dec 3, 2012
Messages
317
Video didn't come thru . Have you checked linkage? Take air silencer off and without starting engine throttle forward and watch inside carburetor and see if the butterfly's are opening and closing .
 

Mingog80

Recruit
Thread starter
Joined
Nov 24, 2015
Messages
3
Video didn't come thru . Have you checked linkage? Take air silencer off and without starting engine throttle forward and watch inside carburetor and see if the butterfly's are opening and closing .

Thank you I just attached the link with the video
 

sutor623

Rear Admiral
Joined
May 23, 2011
Messages
4,089
Does this motor have quickstart? If it does, disconnect the white/black wire from the powerpack and ground the powerpack side to the block. Sounds like the quikstart is changing the timing on you even after the head is warming up which can be an issue with the temp sensor or the powerpack. If that doesn't change anything out a timing light on it and see if the timing is moving from 4-8degrees up to 14-18 degrees during the problem.
 
Last edited:

Mingog80

Recruit
Thread starter
Joined
Nov 24, 2015
Messages
3
Thank you I will try with that.
Does this motor have quickstart? If it does, disconnect the white/black wire from the powerpack and ground the powerpack side to the block. Sounds like the quikstart is changing the timing on you even after the head is warming up which can be an issue with the temp sensor or the powerpack. If that doesn't change anything out a timing light on it and see if the timing is moving from 4-8degrees up to 14-18 degrees during the problem.
 
Top