omc trolling motor resistor question

tsp21367

Recruit
Thread starter
Joined
May 17, 2008
Messages
2
In the process of replacing the resistor I pulled the ring connectors from two of the wires. They had, what seemed to be, extra thick shrink tubing on them. My question is will any shrink tubing work in its place, or is there a specific reason for this thicker tubing? Also should I try to seal the threads on the shaft or is the rubber washer good enough? THANKS!
 

HondaPower

Petty Officer 1st Class
Joined
Apr 28, 2002
Messages
236
Re: omc trolling motor resistor question

I have the complete pages describing the procedure with pictures. There are two separate instructions, one for the HBF2 model and one for all except the HBF2 model. Let me know which one you need.
 

tsp21367

Recruit
Thread starter
Joined
May 17, 2008
Messages
2
Re: omc trolling motor resistor question

Thanks for the reply but I got the info I needed from a local mechanic.
 
Top