zippinbye1
Recruit
- Joined
- Dec 2, 2023
- Messages
- 2
Hi all - my first post here after being a frequent lurker, I finally signed up. Gotta start with something, so here it is ........
Boat in question is a 1998 Four Winns Horizon 240 with a 7.4 Volvo MPI, but that's not too pertinent, as the electrical layout is rather generic .... could be any number of boats, as it has port and starboard marine batteries with a 4 position switch. I'm trailer-stored under cover at my home. Our "winterization" out here in Southern Nevada is pretty tame compared to many parts of the country, since it rarely gets but a few degrees below freezing and when that happens, it's not more than four to eight hours below. In 30+ years living here, I could have left the boat with fresh water in all jacketed areas and escaped damage all but two or three years. An incandesent light bulb in the engine compartment would probably do the trick, but what I do is a flush with RV antifreeze. It's a practical and flexible non-toxic method that allows me to take a spontaneous run on a clear and warm winter day, if I feel the urge. One test fire at the house to purge the antifreeze, and it's off to the lake or river.
In keeping with that simplicity, as opposed to pulling the batteries and float charging them in my shop, I want to attach a battery maintainer with the batteries in place. Can this be accomplished with a single charger? I have good luck with the very inexpensive Harbor Freight units on all my single battery stored vehicles, so wondering if there's a way to sort it out for the boat? Attach to one battery and select the switch to "Both" in order to share charging to the other side? These are the Cen-Tech brand, and are rated at .5 amps - might be a bit week for the cable gauge and distance, approx. 80 inches between batteries with switch in the middle. Or should I just run two chargers independently, with the switch "off?" BTW, I don't think the boat has any parasitic electrical draws - the stereo has a dedicated power switch and no clock or other obvious "vampires." So I do not expect any downstream competition for electricity utilization of the switch is selected to Both
Open to all ideas. TIA
Boat in question is a 1998 Four Winns Horizon 240 with a 7.4 Volvo MPI, but that's not too pertinent, as the electrical layout is rather generic .... could be any number of boats, as it has port and starboard marine batteries with a 4 position switch. I'm trailer-stored under cover at my home. Our "winterization" out here in Southern Nevada is pretty tame compared to many parts of the country, since it rarely gets but a few degrees below freezing and when that happens, it's not more than four to eight hours below. In 30+ years living here, I could have left the boat with fresh water in all jacketed areas and escaped damage all but two or three years. An incandesent light bulb in the engine compartment would probably do the trick, but what I do is a flush with RV antifreeze. It's a practical and flexible non-toxic method that allows me to take a spontaneous run on a clear and warm winter day, if I feel the urge. One test fire at the house to purge the antifreeze, and it's off to the lake or river.
In keeping with that simplicity, as opposed to pulling the batteries and float charging them in my shop, I want to attach a battery maintainer with the batteries in place. Can this be accomplished with a single charger? I have good luck with the very inexpensive Harbor Freight units on all my single battery stored vehicles, so wondering if there's a way to sort it out for the boat? Attach to one battery and select the switch to "Both" in order to share charging to the other side? These are the Cen-Tech brand, and are rated at .5 amps - might be a bit week for the cable gauge and distance, approx. 80 inches between batteries with switch in the middle. Or should I just run two chargers independently, with the switch "off?" BTW, I don't think the boat has any parasitic electrical draws - the stereo has a dedicated power switch and no clock or other obvious "vampires." So I do not expect any downstream competition for electricity utilization of the switch is selected to Both
Open to all ideas. TIA