No spark

Bottom water

Recruit
Thread starter
Joined
Jun 19, 2018
Messages
2
Johnson 1955 3 hp, JW 11, new coils, condensers, wires and points, still no spark is there a kill switch of sorts on this engine to shut it down when handle is moved to the stop position or something else grounding out the ignition, any ideas.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Do you have all the wiring wired properly ?? Double check it.
 

Bottom water

Recruit
Thread starter
Joined
Jun 19, 2018
Messages
2
Took photos before to ensure it went back together the way it came apart. The motor was last run a couple years ago and ran great now no spark on either cylinder, acts like a switch is off but I don't find a kill switch or point of ground out
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If you replaced plug wires, are you sure you have contact at the coils and at the plugs? The motor uses 7mm wire with a solid core.

Facing either of the two coils, the condenser and points on the right are wired to that coil.

The coil closest to the carb fires the top coil (make sure the wires are going to the right plugs).

Points need to be squeaky clean, gapped to .020. Gap is set when the rub arm is at the highest point of the cam.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
New points also need to be thoroughly cleaned. There is no kill circuit on that motor.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Clean the points. Best way is to polish each contact individually before installing them. New points probably have an invisible non-conductive film on them.
 
Top