No spark on one cylinder

Fisherman 41

Recruit
Thread starter
Joined
Jul 7, 2013
Messages
4
I have a 1990 evinrude v4 90 hp. I have a weak/ no spark on one cylinder . You can hear when it kicks in. Has new stator,power pack , coil,and plug wire all other cylinders have good spark. Any ideas on what to check next?
 

sutor623

Rear Admiral
Joined
May 23, 2011
Messages
4,089
You didn't mention timer base. Sounds like the only thing that hasnt been replaced. You need to get a DVA meter and check cranking voltage at the timer base. Another thing you can do is check each timer lead to ground and see if you have a short to ground.

How do you know there is weak spark? Did you put the coil wire onto a spark tester, or are you just assuming it is spark?

Did you try swapping the ignition coil with another coil on the motor to see if the issue moves? Are these new coils aftermarket? I have a V4 looper and have had aftermarket (CDI) ignition coils fail right out of the box!!
 

sutor623

Rear Admiral
Joined
May 23, 2011
Messages
4,089
The link to CDI in my signature will give you detailed instructions to figure out where your issue is. And swap coils to see if it follows. I have seriously had bad luck with new ignition coils.
 
Top