No power after new ignition install

dazednconfused

Recruit
Thread starter
Joined
Jun 8, 2017
Messages
2
Please save me!!! I lost my keys so I threw on a push to choke style (just like my old one) switch. It would turn over fine but would not start. I talked to the local Cabela's repair shop and he said I wired it wrong. Well be in a hurry I did not disconnect the battery and when I tried to fix my wiring dilemma I spark off another wire and NOTHING will work now. I checked the 20 amp fuse under the cowl and made sure nothing on the panel was tripped. I swapped a relay and now am at a dead end. I have read forums on this motor that talk about fuses but for the life of me I can't find anything blown. What could I be missing????

I checked the wires for breaks/burns
I checked all around my battery and wiring for more inlines
I reset everything on the panel

1999 Evinrude Ficht 200HP
2000 Stratos 19 SS Exterme
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Get a laptop hooked up to it and see if you have any codes.
 

dazednconfused

Recruit
Thread starter
Joined
Jun 8, 2017
Messages
2
I found a shop that will sell me a cord and diagnostic cable but said they do not troubleshoot Ficht motors :( I will grab that on Monday. Is there a fuse that I may be missing?
 
Top