Newbie with a 1979 75hp Stinger w/shift issues.

cosmic12

Recruit
Thread starter
Joined
Jun 9, 2017
Messages
1
First, Hello and thank you all for the info I have gathered being a bit of a lurker here. Figured it was about time I joined.
I just got a 79 75hp 3cyl Stinger with a bad gear case, was told someone put the wrong (to small) prop on it and over wound it and blew out the gears, whatever the reason it was junk. I found another one that seems to be the same all looks correct. I pressure tested it all good. Installed a new pump and put it on the engine and now it won't shift into foreword. Net/rev fine. I am thinking (after searching here) the shift rod has been turned out of adjustment. Can someone please tell me the correct way to get it where it should be? I am very confused over the info I have found, this being the !st Johnson I have ever had or worked on. I do find most everything much easier to deal with than every Merc I have had and thats why I bought it but I have a learning curve ahead of me. Again confused about the rod adjustment and what it should be.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Shift rod height is 21 23/32 " in neutral. Measure from the top of housing to the center of the shift rod hole.
 
Top