New member needing help

xchief

Recruit
Thread starter
Joined
Feb 8, 2017
Messages
2
Trying to rebuild a 1975 70 HP Evinrude. Got it fired up on a flush tube/hose and it run well but I do not see any water from a pee spout. I do not even see where a hole is located. New water pump installed. does it just discharge water through the exhaust (2 holes) near the center near the top?????? I did see in service manual that there would not be much discharge using a flush hose. Am I ok to go run it in the water for its first real test????
 
Last edited by a moderator:

daselbee

Commander
Joined
Jan 20, 2009
Messages
2,765
Look on the PORT side of the engine, and examine the flat exhaust cover. There should be an elbow with a hose attached which is your indicator (pee indicator).
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Sure it is a 1995 model ?-----A model # helps.-------The 95 models all had a hose coming off the exhaust manifold and led to a fitting in lower cowling.

Mod EDIT: Typo in 1st post, its a 1975
 
Last edited by a moderator:

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
The two holes at the base of the lower cowl are bypass ports. Unless the boat is in the water you would not see much water exiting there. In the water means there is much more backpressure on the exhaust going out the hub of the prop so the bypass ports relieve that pressure to promote good idling.
 

xchief

Recruit
Thread starter
Joined
Feb 8, 2017
Messages
2
Sorry about the date. Its a 1975. not 95. Thanks Silvertip, so you are saying on a flush connection, I will not see much water being circulated. In the water running, I should see water/exhaust coming from the two holes in the rear of the engine below the cowling ???
 
Top