New Boater with GPS and VHF mounting question

Jason H

Recruit
Thread starter
Joined
May 13, 2008
Messages
3
Hi guys

New here and thought I'd say hi and try and learn a little before I jumped in and started cutting holes in my new boat. First, the basic information:

BOAT
Sea Hunt 196 Ultra W/150 Yam
Center Console
standard.jpg

standard.jpg


Just bought a ICOM IC-M304 VHF Radio and a Garmin 540S GPS/ Depth finder. My plans are to flush mount both units in the dash. I am new to boats but mechanically sound. Is there anything that I might not consider in the cutting of the Fiberglass, mounting of the transducers, connecting of the wires, ect..., that could cause me problems? Like I said before, I no nothing of electronics but can usually figure out most things by reading the directions. What directions don't tell you is how it's really going to play out once you've cut that first hole or the EASIEST way to really do something.

I guess what I'm trying to do is learn from others mistakes in the hopes that I don't make the same and can one day repay the favor.

Thanks in advance for any information

Jason Harley
 

Zero Balance

Petty Officer 2nd Class
Joined
Jul 11, 2007
Messages
152
Re: New Boater with GPS and VHF mounting question

Keep your VHF and your GPS antennas as far away from each other as possible. At least 4 ft. apart. If you have an internal antenna in the GPS try to mount your VHF antenna accordingly.


Oh yeah.... Measure twice cut once....:D
 

Boatist

Rear Admiral
Joined
Apr 22, 2002
Messages
4,552
Re: New Boater with GPS and VHF mounting question

Jason
Welcome to the board and that may be the Best First Post I have ever seen.
Looking at your nice new boat it looks like you do not have a lot of structure that might block your GPS antenna.

I am not sure if the fiberglass would degrade the signal to your GPS or not. Canvas tops and windsheilds have almost no effect.

The VHF Antenna should not be closer to the Radio than 3 feet as when transmiting it can overload some of the internal oscillators.

Only thing you may want to consider is if you plan to keep the boat for a long time you likely will change your radio, Depthfinder, GPS as newer products come out. Do not get me wrong the products you listed are top of the line and will likely last 20 years or more.

My boat the Depth finder and Loran C are both 27 years old and still work perfect.
I take my Radio, Fish Finder, Loran C, GPS units Inside after every trip.
I do this for two reasons.
1: It reduces the chance of being stolen.
2: I belive it increases the life of the gear. Example My boat in on the trailer in the back yard and cover with a dark blue Sunbrella cover. From June to the end of Sep the inside temperature of the boat will reach 140 degrees plus every day.
I feel strongly that that kind of temperature will shorten the life of electronics.

Flush Mounting looks very nice but you may also want to consider flushing mounting in a electronics box that you made out of Starboard and in on the top of the dash. This way when you get a different radio 5 years from now that has a different shape your just buy a new piece of starboard and cut the new Shape.

Again welcome to the board, a lot of good people here willimg to give ideas and help.

Bodega Bay Weather May 13 2008
Winds NW 320 degrees true at 23 knots with Gust to 27.2 knots. Water Temperature 48.1degrees
Seas 7.9 feet every 8 seconds, chop 5.6 seconds, Wave Steepness = Steep
 

Jason H

Recruit
Thread starter
Joined
May 13, 2008
Messages
3
Re: New Boater with GPS and VHF mounting question

Thanks for the replys.

I have a new dilemma. I lieu of cutting holes in the dash and later changing out equipment as Boatist has noted, I am going ahead and having a T-Top W/Ele Box installed next week. I wanted one anyway, this just gave me my excuse. From the posts below, I am assuming I should put the GPS antenna on one of the far sides above the Radio and the Radio Antenna and the other side above the GPS? Three feet is about the limit I can get as far a distance from Radio to Antenna.


Jason
 

Expidia

Commander
Joined
Aug 26, 2006
Messages
2,374
Re: New Boater with GPS and VHF mounting question

Welcome :)

Here is my take on this as I hate drilling holes since I like to trade up from time to time and I think it improves the resale. I also like to move all my electronics up to the next boat, so I buy the best I can afford. I don't like to "toss them in" as a package when I sell. I think I've accumulated over $4000 of accessories already.

When I sell a boat it's pretty close to how it arrived from the factory. I find buyer's love this since it's like they are buying a brand new boat and can customize it now to their liking. I'm on my fifth boat and ready to move up to another.

I totally agree with Boatist's comments.

I like his idea of mounting the stuff on a removable frame, so you don't have to cut big holes.

I perused several boating forums before I bought my equipment.

You're not going to want to hear this because you've already decided and bought your electronics but . . . .

Theft was "my" main concern because I trailer a lot and also leave my rig in motels and restaurant parking lots, my backyard etc.

My memory's of years ago going down to my Brother 36 foot boat (in a protected marina no less) only to find all his electronics stolen on several different occasions. This tends to put a damper on your day.

And in an always open rig theft is always going to be an issue.

I don't like to trailer around with the electronics always getting shaken up either or as boatist says "leaving all under a hot tarp".

So I bought all "instantly" detachable units with no wires to disconnect for the GPS combo: Hummingbird ($999) 797 c2 SI (side imaging) 1 button, it's off.
For the VHF/DSC I went with a Standard Horizon PS2000 black box ($185) which the unit is hidden under the dash and only the "detachable" mike which controls all, shows and hangs off the dash on a bracket that fastens on with two small screws. It also has a loud and clear built in speaker too.

The only thing I cut in was the stereo since on this boat because space is at a premium and I didn't want it hanging down by my feet and most stereos are a standard size for that cutout anyway. It's a Marine grade Kenwood ($135) am/fm cd, Ipod adapter and I added the splash shield. It also has a detachable face plate.
I move my Sirius unit from car to boat, 3 wires just plug into the side of it. I bought an extra Sirius antenna ($20) that I wired into the boat.

I store all the electronics in a water tight Pelican 1200 case in my trunk. These cases are so amazing that I just ordered a bigger one (the 1400) to use as water tight down to 30 feet, floating kit for tools, first aid, flares camera cell phone etc.

So before you unholster that drill . . . that's my take on the subject.

That's a really nice boat too! Congrats :D

My link below shows 2 pages of pics of the various installations. Click on a pic to enlarge it.
 

dingbat

Supreme Mariner
Joined
Nov 20, 2001
Messages
17,404
Re: New Boater with GPS and VHF mounting question

You should be all right with that setup. I have a hardtop on my rig and I mounted the VHF antenna on the port side. The GPS is mounted in the center and the AM/FM antenna on the starboard side. No problems with interference.

Take a close look at putting your electronics in a box over head. The electronics in my boat where installed overhead and it was a pain, literally, to keep looking up and away to see anything.

In the end I installed the AM/FM/CD player and VHF in the overhead electronics box, surface mounted the FF and flush mounted the GPS/ radar at the helm.

Now both my FF and navigation systems are viewable without moving my head or taking my eyes off the ?road?.

I don't like to trailer around with the electronics always getting shaken up either
My electroincs take more of a beating running the 25 miles out to the fishing grounds than they do in a 2 years of trailering. ;)
 

waterinthefuel

Commander
Joined
Nov 15, 2003
Messages
2,729
Re: New Boater with GPS and VHF mounting question

I'm going to limit my reply here. I think enough good information has been stated. I want to repeat one thing though, you blew into this forum with a very impressive first post.

That being said....electronics do benefit from not being jolted. No wave can mimic a good solid pothole at 55mph. I would definitely support taking them out of the boat to trailer it. Why not? What does it hurt, and what does it cost? Over the years it may jolt the wrong connection and leave you without electronics when you get where you're going.

I remove EVERYTHING from my boat to trailer it, including the lights. Those things are so finicky, if they work it's a miracle in itself. Everything that isn't bolted down comes out.
 

Boatist

Rear Admiral
Joined
Apr 22, 2002
Messages
4,552
Re: New Boater with GPS and VHF mounting question

If you do decide to remove your electronics there are lots of quick release type mounts where you push one lever and the whole unit comes off.

I have it easy when we go to the ocean as a member of my crew will take a rest room break then reboard. We always flush the motors and wash the boat and trailer. When we get to the wash station they have a 5 to 15 minute time limit but never enforced still I like to get it done and get out of the way. I set up my boat where I can run both motors and wash the boat at the same time. I have a Y hose adapter with shut off valves on both outputs that I screw on to the fosset. I connect my motor flush hose to one Y output.
The hose has a washer to limit the amount of water to the motors that hose has a another Y adapter with shut off valves and out outputs go to the I/O and the other to the Outboard kicker. Turn the water on and have son on board start both motors. Then I hook up my second hose to wash down the the boat, trailer Poles, nets, pliers, ect.
By the time I get water flowing my Son already has all the electronics removed and put into their waterproof boxes and stored in the lockable bow area.

I recomended eveyone set there boats up like this as has several advantages. I can flush both motors longer, wash the boat longer, wash the trailer and brakes longer, wash the poles, nets, gafs, pole holder, EZ steer longer than other and still get done and out of the way faster.

So many hook up the I/O and flush, then hook up the Kicker and flush, then wash the boat trailer and gear.

Before they get the second motor flushed I am already done and have flushed motors longer and washed the boat, trailer and gear longer.

Where I boat most in the ocean they only have 4 boat wash stations and almost everyone comes in near 1400 before so it gets real busy at the wash station and the fish cleaning station.

Bodega Bay Weather May 15 Finally GREAT Weather
Winds West at 270 degrees true at 7.8 knots with gust to 9.7 knots water 48.9 degrees F
Seas 5.9 FEET every 13 Seconds, Swell Steepness = Swell
 

Jason H

Recruit
Thread starter
Joined
May 13, 2008
Messages
3
Re: New Boater with GPS and VHF mounting question

Thanks again everyone for the responses. I am overwhelmed with the insight, knowledge, and overall helpfulness this forum has already provided me. I have had many other questions that I have not had to ask, merely "searched" out from the past queries. As I said in my first post, in the future I hope to be a contributing member of this forum as I know my love for boating will only grow with time as well as my knowledge thanks to all of you.

P.S.
My plan as of now is to mount the radio in the electronics box on the T-Top, Flush mount the GPS/Depth Finder in the dash, and set both up for some kind of quick disconnect (if available for flush mount) as Boatist has recommended. I do plan to remove the electronics after each trip before I trailer the boat due to potholes and such. My concern for mounting the GPS above in the T-Top is strictly from the logistical stand point of having to look up all the time. It just seams like in the dash, I would be able to navigate shallows easier by looking straight ahead and watching the GPS in my peripheral vision. Maybe this isn't the case, but it's what seams easiest from a laymen?s point of view. I know it?s kind of six one way, half dozen the other whether I look up or down. Any experience with visual perception?
 

dingbat

Supreme Mariner
Joined
Nov 20, 2001
Messages
17,404
Re: New Boater with GPS and VHF mounting question

From an ergonomics stand point you should not have to physically move your head to see navigational equipment. Instrumentation should be visible in your peripheral vision.

As stated in my earlier post the guy I bought my boat from mounted the GPS in the overhead electronics box and I had to physically raise my head and look away from the water to see the display. Outside of being in a less than ideal location more times that not I ended up with an aching neck at the end of the day as well.
 
Top