Need some assistance please!

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
I have just rescued my 2006 Tahoe 195 OB from almost three years of being held hostage (divorce settlement) and am trying to get it back in the water. Obviously I had to replace all three batteries, change the oil in the Mercury 115 Optimax, and drain the fuel tank... not too mention the deep cleaning involved.

Here's the problem...

After replacing the batteries and making sure they were charged fully (onboard charger), I have power to the dash, but no power to the trim or engine.

I have check all the fuses that I know of (and can reach), cleaned all the connections I can access, and ohmed out the ignition switch. I have no idea where the wiring harness plugs and such are and nothing to point me as to where they are or if I can actually reach them.

Suggestions?

Thanks for your assistance...
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Need some assistance please!

Did you check the fuses under the engine cover? Those/it typically prevents starter engagement and trim operation. The console is fed by a separate circuit from the battery.
 

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
Re: Need some assistance please!

Thanks, I really appreciate your response! I did check the fuses, and they were all good... 2 - 20 Amp fuses and a 1 - 5 Amp fuse. The wiring diagrams I was able to get show that there is a separate circuit, but they are NOT clear on where the harness and plugs may be, and my fat behind can't crawl in past the batteries to get in the aft portion of the boat.
 

j_martin

Admiral
Joined
Sep 22, 2006
Messages
7,474
Re: Need some assistance please!

There's one positive lead to the battery still laying in the bottom of the boat.........

or maybe it's black and got put on the negative post.
 

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
Re: Need some assistance please!

I will check that out, thank you for the reply also.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Need some assistance please!

The harness and plugs for an outboard are under the engine cover. There generally are no others as the harness runs up to the control throttle/shift control box. For the starter to work both large battery cables must be connected to the battery and the connections need to be clean and tight -- on both ends. If the engine is not in neutral or if the neutral start switch is bad, the starter won't work. Sitting for three years the trim relays may be corroded.
 

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
Re: Need some assistance please!

Once again, thank you for the suggestions. I will check on these after work today.
 

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
Re: Need some assistance please!

Checked all that was suggested last night (after being sent out of town for two days) and as it turns out there was some corrosion on the trim relays AND a cable NOT connected to the battery. IT had apparently fallen behind when I installed the new one.
Thanks for all your assistance, and now I just have to get all the old gas out and put some new in to see where I am with the engine.

I appreciate the assist gents...
 

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
Re: Need some assistance please!

Well... got everything working and was going to take her out tomorrow.

Started her up and the Mercury 115 was sounding good. I went to turn the steering wheel and it is locked up tight. It was working as of two days ago...

HELP!?
 

j_martin

Admiral
Joined
Sep 22, 2006
Messages
7,474
Re: Need some assistance please!

Did you grease the steering cable? They don't like that.
 

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
Re: Need some assistance please!

No, I did not grease the steering cable... as it was sitting for a number of years, I'm looking at the push/pull rods by the motor and the aft rod is trying to move but the one further forward is stationary.
 

j_martin

Admiral
Joined
Sep 22, 2006
Messages
7,474
Re: Need some assistance please!

The forward one is the one that usually has the grease fitting on it you don't want to use.
So anyway, something has worked it's way into the forward cable on a dual rack (probably) system. Manufacturer says the cable has to be replaced.

Some of us decided to figure out how to clean and lube them. Here's a thread on Scream and Fly about it.

http://www.screamandfly.com/showthread.php?188864-Steering-Cable-Lube
 

JDeez

Cadet
Thread starter
Joined
Aug 8, 2011
Messages
8
Re: Need some assistance please!

Will look into this, and just wanted to say "Thank You" for all the assistance so far.

The code of mariners prevails...
 
Top