Need help with repairing old motor

thekman

Recruit
Thread starter
Joined
Jul 25, 2016
Messages
1
I have a 1940 Johnson LT10 thats not getting any spark. I have determined that it is the ignition coil. I have been searching the internet but cant find a replacement. Does anyone know if this is a part that I could find somewhere or if I could adapt a newer model coil to work? Any insight would be appreciated.
 

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
:welcome: thekman to iboats. Nice to have you aboard...

On those older engines parts can be tricky to procure. I have zero knowledge about that engine. Is it an external coil or underneath the flywheel? If it is an external coil, then you may be able to use another coil setup to get it running. Post a picture or three for us to see. There are a lot of folks on these forums and someone may even have one to fit, OR can direct you to a vender to buy one. :noidea:
 

HighTrim

Supreme Mariner
Joined
Jun 21, 2007
Messages
10,486
Welcome.

The LT10 coil can still be had. Place a wanted ad at aomci.org in the classifieds. Or, using your old lamination, you can transplant a modern coil onto your old lamination. Bit of work, but can be done. Easiest solution would be to find a NOS or good used one.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Are you sure its the coil? Those pre WWII Johnson coils are pretty robust. The condensers are often the weak spot. Also, the points must be clean!
 
Top