need help with 4.5hp evinrude 1974

monsterfish878

Recruit
Thread starter
Joined
Jun 5, 2016
Messages
3
So I have a 1974 evinrude 4.5hp, and well I'm not sure what to look at next. I have had about 15 hours of running time on it in the last 3 months and everything has been great until I ran in out of gas. the next time I took it out it fluttered when I tried to give it more throttle or when I put in gear. So I took a part the carburetor, fuel lines and gas tank and found that had need some major cleaning. So I got everything put back together, didn't do a carburetor kit but I didn't think it needed one because seals were in good shape. Now it won't run for long or will not start or hard to start, please I need some help getting this thing running because I want to take my dad fishing this next week and my brain is fried from coming up with ideas on how to fix?! Thanks if anyone can help.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Was the carb dirty? May be debris in the idle circuit underneath the welsh plug on top of the carb. A carb kit will have a new plug so you can remove the old one and clean it out underneath. Also, check the filter in the fuel pump - may be debris in there.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Does spark on this motor jump a gap of 5/16" or more, yes or no.----This motor has 2 newer coils or it needs a set !
 

monsterfish878

Recruit
Thread starter
Joined
Jun 5, 2016
Messages
3
Thanks for ya'lls help! Took it out today and got to run but Boggs down still, but at least it runs! Yeah! Not idling all that great but after I check plugs again and point will move to coils or punt!? and it is a 1976 not a 1974, my boat is 1974 aluimcraft, I get those two flipped, thanks again! If y'all have any more weird ideas to look at any help will be appreciated!
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
I do not think they made a 4.5 hp during the 1970s. So If it is really a 4.5 it is probably from the 1980s or later. If you can give the model number it would help others here to help you. Running a then bogging down could indicate it is running only on one cylinder. Start it and with some insulated pliers pull off one spark plug wire at a time and see what happens. An example if you pull the top one off and it runs than the bottom one is firing. Repeat this for the other cylinder.
 

monsterfish878

Recruit
Thread starter
Joined
Jun 5, 2016
Messages
3
Yeah , I didn't think of that and this afternoon ill put on here my model, away from motor right now, emergency, thanks will post later
 
Top