Hello, I got this 1979 motor (#5398664) last spring for parts, but compression was 120 and it had good spark, so I rebuilt carb and put new water pump. Motor ran great in the tank.
I did not have boat for that and left it sitting in the garage.
Last week I put it on 12' aluminum and it did not want to start.
Back in the tank it started with drill starter and died in a few min.
No spark.
I removed kill switch wire - did not help.
I am OMC person, this is my 3rd Merc only, so can use some help.
My first suspicion is coil and with OMC I just buy new one for $25, but this one is $150, so I prefer to buy only if I know it is bad.
See pics below: Primary reads significantly higher than book says and secondary shows no continuity. Is coil bad? Is this valid test or should I check also something else?
Also, catalogs show these 2 coils for their engine:
336-4528A 3
Any advice is greatly appreciated.
I did not have boat for that and left it sitting in the garage.
Last week I put it on 12' aluminum and it did not want to start.
Back in the tank it started with drill starter and died in a few min.
No spark.
I removed kill switch wire - did not help.
I am OMC person, this is my 3rd Merc only, so can use some help.
My first suspicion is coil and with OMC I just buy new one for $25, but this one is $150, so I prefer to buy only if I know it is bad.
See pics below: Primary reads significantly higher than book says and secondary shows no continuity. Is coil bad? Is this valid test or should I check also something else?
Also, catalogs show these 2 coils for their engine:
336-4528A 2
336-4528T 2
Is this coil below the same? Will it work? See last pic.336-4528A 3
Any advice is greatly appreciated.