need help identifying

Thoughtshurt

Cadet
Thread starter
Joined
Apr 18, 2016
Messages
18
I just purchased a boat they said it didn't have spark so they had removed the distributor. its a 65 evinrude 75hp and I am trying to figure out what the two lines r that are between the heads of the motor the bottom one runs to the carbs wich is for the choke but what would the top one be there is nothing attached to it and cant see where the other end of the line would attach
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
I am going to assume you are talking about the steel tube that goes to the choke.-----That tube carries warm / hot air to the bimettalic spring to control choke.-So the other fitting that is open is where the air goes in .---It then goes through a wee heat exchanger in the exhaust manifold before going into into the tube.---I have seen that fitting plugged by folks who simply do not know how things work.
 

Thoughtshurt

Cadet
Thread starter
Joined
Apr 18, 2016
Messages
18
Ok thank you so much for your help it had a threaded post so i just assumed it was ment to have something attached to it and that is why i figured i would ask first thank you again!!
 
Top