Need help. Can't trim up under load.

Capsoshiefan

Recruit
Thread starter
Joined
Jun 20, 2016
Messages
2
Start by saying this is my first boat and I'll probly have a million questions. so thank in advance for any and all help. I recently got a 1995 Nitro 190DC bass boat with a evinrude xp150. First Time out throttle cable broke. But I learned it floated and didn't take on water.checked all pumps and are working before first venture. Got cable replaced took boat out and boat would not plane due to it would not trim up under load. Works fine out of water even when idling. I trimmed up a little and slowly worked throttle up and at about 40% would push all the way back down. Checked fluid and fluid is full. Has a detwiler Inc. Plate as well. Is there any test or other things to check before I dish out the money for a marina to look at it. I am a car mechanic so I am mechanically inclined just never owned or worked on a boat. Thanks for any help.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
How high was the motor trimmed out? Were you on the tilt ram or the trim rams? Make sure the manual release on the T/N/T is closed and fluid needs to be checked in the full up position. When you replaced the throttle cable did you make sure the carbs are opening all the way. Do a compression test and a spark test make sure all cylinders are firing.
 
Last edited:

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
You could try replacing the tilt/trim manual release valve and see what happens.
 

Capsoshiefan

Recruit
Thread starter
Joined
Jun 20, 2016
Messages
2
Cable is good. Carbs are opening all the way. Spark is good. Based on a video I found the manual release is closed. Compression is at 90 on all cylinders. Which seems very low but have not found specs for this engine. Thanks for the helps. Think I'm just going to drop it off at a shop. May have a boat for sale soon
 
Top