My motor to short?

Xtyfighterx

Cadet
Thread starter
Joined
Oct 2, 2016
Messages
8
Have a 25hp Johnson on my 14ft Lund. I got it running. And idling nice took it out and anything past half throttle it feels like it's going in and out of gear like the shaft isn't far enough in the water anyone heard of this?
 

CV16

Chief Petty Officer
Joined
Aug 30, 2007
Messages
445
Post up a pic so we can see where it sits. A good level shot will work best.
 

Xtyfighterx

Cadet
Thread starter
Joined
Oct 2, 2016
Messages
8
I'm thinking my forward gear is worn or clutch dog the more
I'm reading. It's fine at low and mid speed but when I throttle up it's like it's slipping. Kinda how a clutch slips in a car
 

Vic.S

Rear Admiral
Joined
May 4, 2004
Messages
4,721
I'm thinking my forward gear is worn or clutch dog the more
I'm reading. It's fine at low and mid speed but when I throttle up it's like it's slipping. Kinda how a clutch slips in a car
Sounds like the classic symptoms of a spun prop hub

A worn dog clutch would simply jump out of gear
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
^^^^yep if its a smoothish slipp with no clicking or clunking remove prop, make a mark on the metal on either side of the rubber hub, run under load til ot slips. Inspect marks and see if they still line up.
 

Tim Frank

Vice Admiral
Joined
Jul 29, 2008
Messages
5,354
Your OP is nor very clear.
Clutch dog and prop hub have been suggested already.
But....
If it is over-revving at WOT suddenly, and the motor is new to you, make sure that the shaft length is correct for the boat.
 
Top