bwingler57
Petty Officer 3rd Class
- Joined
- Jun 24, 2017
- Messages
- 79
No Title
Hey Mac, here is the console totally taken apart with a dimension sheet. If you decide to build it add an extra 2 inches on the size of the drawing, each flange is 1 inch per side. The front and back is 3/4' ply and both are the same, they attach with machine screws and nuts. Also the top and side was cut from one piece and bent 90 degrees and a small angle is riveted on to the out side edge. Bottom of leg has 2 holes that screwed to the floor.
Hey Mac, here is the console totally taken apart with a dimension sheet. If you decide to build it add an extra 2 inches on the size of the drawing, each flange is 1 inch per side. The front and back is 3/4' ply and both are the same, they attach with machine screws and nuts. Also the top and side was cut from one piece and bent 90 degrees and a small angle is riveted on to the out side edge. Bottom of leg has 2 holes that screwed to the floor.
Attachments
-
photo277271.jpg113.4 KB · Views: 1
-
photo277272.jpg117.6 KB · Views: 1
-
photo277273.jpg129.2 KB · Views: 1
-
photo277274.jpg147.8 KB · Views: 1
-
photo277275.jpg154.8 KB · Views: 1
-
photo277276.jpg168.8 KB · Views: 1
-
photo277277.jpg101.3 KB · Views: 1
-
photo277278.jpg95.4 KB · Views: 1
-
photo277279.jpg133.3 KB · Views: 1
-
photo277280.jpg140.1 KB · Views: 1
-
photo277281.jpg153.9 KB · Views: 1
Last edited: