Moving the throttle and ignition cabling - where to disconnect

slorentz

Recruit
Thread starter
Joined
May 5, 2011
Messages
1
I'm installing a new console on our pontoon and would like to move the cables for the throttle and ignition. On the old console, it came up inside, thru a hole cut in the side, then up to the controls that were mounted on the side of the console. It rather have it come up thru the floor on the side of the console, not inside. Do I disconenct the cables in the throttle control or back at the motor and fish back thru? Any tips on this task would be helpful too.

'90 Manitou pontoon, '92 Evinrude 60hp
 

Lyle29464

Lieutenant
Joined
Mar 10, 2009
Messages
1,261
Re: Moving the throttle and ignition cabling - where to disconnect

Taking the box apart is kind of open and shut.

If you can tie a string to the old cables and pull them out you use the string to pull them back in. Sounds like you need to pull them part way to reroute them.

Always pull in an extra string in case something goes wrong or you want to add a wire later.
Often the cables are tied for support and require access to cut the tie straps. Some boats are a real hassle to change cables. So it depend on how the cables are installed.
 
Top