Motorguide Brute Problem

jkurtkrauss

Recruit
Thread starter
Joined
Jul 5, 2011
Messages
2
24V 55lb thrust will stop working if I run it continuously for 4-5 minutes at a high speed. Even if set in the "continuous" setting on the selector switch. If I give it time it starts working again like its a thermal overload issue. (?) Circuit breaker on battery doesn't trip as far as I can tell.

I never get the problem if I use it intermittently during normal fishing. Its been like this for several years.

Any ideas? I was thinking bad switch????


Thanks!
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Motorguide Brute Problem

Only a voltmeter or test light will tell you if the circuit breaker is opening and closing. That is the most logical answer. There is nothing else in the system that will open and then automatically reset. YOu can't look at a breaker to see if it is open or closed unless it has a manual reset button on it and I suspect yours does not. If it is the breaker it is due for replacement with the proper size. A breaker that has been cycled many times derates. While it may be a 50 amp breaker for example, after many cycles of on/off it may now open at 40 amps (or less).
 
Top